Lenco CS-450 CD - Manual (Page 4)

3
(FLAT/CLASSIC/ROCK/POP)->VOL(LAST/DEFA) ->MONO/STEREO(only for
FM mode) ->LOUD(ON/OFF)->LOCAL/DX(only for FM mode)->CLK(ON/OFF)
->CLK(12/24)mode.
After selecting the desired mode, rotate the VOL knob to select one setup item of the desired mode.
1)TA ON/OFF
When TA mode is on(TA is displayed on LCD), it will begin to seek TA station and TA SEEK will be
displayed on LCD for a while.
When traffic announcement is transmitted:
a) If the unit is in SD, USB or disc mode, it will switch to radio mode temporarily.
b) Temporarily switch over to an EON linked station when EON detects a traffic announcement on that
other program, and TP will be displayed on LCD.
c) If volume level is below 20, volume level is raised to 20, and returns to its previous mode and volume
level when the traffic announcement is over.
If volume is adjusted during traffic announcement, only the traffic announcement volume is valid.
* TA interruption function:
The current traffic announcement is cancelled by pressing this key. But the TA mode will not be off.
* When TA is on, SEEK, (SCAN), AUTO MEMORY function can be received or saved only when traffic
program identification code has been received.
When TA is ON, traffic program identification code is not received during specified time.
2)AF (ON/OFF)
When AF switching mode is selected and the state of AF switching mode is displayed by AF segment
in display.
Segment off: AF switching mode off.
Segment on: AF switching mode on, and has RDS information.
Segment flashing: AF switching mode on, but RDS information is not received yet.
When AF switching mode is selected, the radio checks the signal strength of AF all the time. The
interval of checking time of each AFs depends on the signal strength of current station, from a few
minute for strong station to a few seconds for weak station. Every time that new AF is stronger than
current station, it switches
over to that frequency for very short time, and NEW FREQUENCY is displayed for 1-2 second.
Because the mute time of AF switching or checking time is very short, it is almost inaudible in case of
normal program.
During FM mode, when AF is on, SEEK, (SCAN), AUTO-MEMORY function can only receive and
save RDS program.
3) TA SEEK/TA ALARM:
TA SEEK mode: when newly tuned station does not receive TP information for 5 seconds, the radio
retunes to next station which has a different PI to the last station, but has the TP information.
When TP information gets lost at the current station for retune time which is set by RETUNE
SHORT(90 seconds) or RETUNE LONG(150 seconds), the radio starts to retune to next same PI
station. When same PI station does not receive in 1 cyclic search, the radio retunes to next station
with TP information.