Lenco CR-2003 - Manual (Page 13)

The number of bars in the wireless symbol in front of the network
name (SSID) shows the relative signal strength of the network.
The key symbol indicates that the network is password-protected.
If the device does not find any wireless networks, No wireless
Networks Found appears on the display. Change your location, if
necessary, and check your WLAN router.
You can find the SSID of your Access Point in the configuration of
the Access Point (router).
Select your network and confirm with OK.
If your WLAN is
password - protected , you will be prompted to enter your
password .
Enter the password using the number and letter buttons of the
remote control or enter it directly on the device.
Note the use of upper and lower case when entering the
password.
You can rotate reel to choose the code. If it is accidentally
pressed to
move a redundant entry , press to
correct .
With Remote control:
The cursor indicates the current entry space.
Press the corresponding number button repeatedly:
0 0 (delete entry)
1
1 (space) @ ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? [ \ ] ^ _ ` { |
} ~
2
2 A B C a b c
3 3 D E F d e f
4 4 G H I g h i
5 5 J K L j k l
6 6 M N O m n o
7 P Q R S p q r s
13