Lenco BTT-6 - Manual (Page 6)

6
Exploring the remote control
1. Infrared LED, this LED sends infrared signals to the main unit.
2.
Standby button, press this button to turn the device on or off.
3. BT button, press this button to enter the Bluetooth® mode.
4. AUX button, press this button to enter the AUX mode.
5. MEM button, use this button to save radio stations.
6. Volume + / - buttons, press the volume + button to increase the volume. Press
the volume
– button to decrease the volume.
7. Mute button, press this button to turn off the volume, press it again to turn the
volume back on.
8. Mode button
, use this button to set the clock’s 12 / 24 hour display.
9. Sleep button, press this button to set the sleep timer.
10. RADIO button, press this button to enter the FM radio mode.
11.
play / pause button, press this button to start the audio playback. If a file is
being played, press this button to pause playback ².
12. ST. / MONO button, press this button to switch between stereo and mono
reception ¹.
13. CH+ / CH- buttons, press the CH+ button to go to the next preset radio station.
Press the CH- button to go to the previous preset radio station ¹.
14. Fine tuning + / - / / buttons
in Bluetooth® mode: Press the button to go to the next song. Press the
button to go to the previous song.
in radio mode: Press the + button to raise the frequency. Press the
– button to
lower the frequency.
15. DIMMER button, press this button to set the display backlight level.
16. Battery compartment, open this compartment to install or replace the battery.
¹ This feature is only available in the radio mode.
² This feature is only available in the Bluetooth® mode.
1
2
3
5
4
6
7
8
9
10
11
12
13
14
15
16