Lenco BT-4304 - Manual (Page 10)

NOTE: No naked flames such as candles should be placed on the radio.
This unit has been produced according to all current safety regulations. The following safety tips should
safeguard users against careless use and the dangers connected with such use.
 Although this unit has been carefully manufactured and rigorously checked before leaving the factory, as with
all electrical appliances, it is possible for problems to develop. If you notice smoke, an excessive build up of
heat or any other unexpected phenomena, you should disconnect the plug from the mains power socket
immediately.
 This unit is a class II device. It does not require a grounded connection.
 Ensure that the unit is sufficiently ventilated!
 The mains plug or appliance coupler is used as the disconnect device, the disconnect device shall remain
readily operable.
 This unit must operate on a power source specified on the specification label. If you are not sure of the type
of power supply used in your home, consult your dealer or local power company.
 The socket outlet must be installed near the equipment and must be easily accessible.
 Do not overload AC outlets or extension cords. Overloading can cause fire or electric shock.
 Keep away from rodents. Rodents enjoy biting into power cords.
 Always hold the plug when pulling out the plug from the mains supply socket. Do not pull the power cord.
This can cause a short circuit.
 Avoid placing the unit on any surface, which may be subject to vibrations or shocks.
 When the unit is not used for long periods of time, unplug the AC power cable for safety reasons.
 To clean the unit, use a soft dry cloth. Do NOT use solvents or petrol based fluids. For stubborn stains, you
may use a damp cloth with dilute detergent.
 When the unit will not be used for a longer period of time, remove the batteries to avoid damage which can
be caused by battery leakage or corrosion.
Declaration of Conformity
Products with the CE marking comply with the EMC Directive (2004/108/EC) and the Low Voltage
Directive (2006/95/EC) issued by the Commission of the European Community.