Specifications, Ztr classic – Dixon ZTRCLASSIC User Manual
Page 13
13
SPECIFICATIONS
ZTR Classic
CHASSIS:
11 GA welded rectangular tubing
BODY:
All body parts made of high density polyethylene. Dent
and corrosion resistant. Front body contains access
panel for battery service.
MOWER DECK:
13 GA stamped steel construction. Three blades
combine for a 42 cut width. Cut height approximately
1- 4 via 7-position lift handle.
BLADE DRIVE:
Electric clutch.
TRANSMISSION:
Each rear wheel is independently driven by chain and
sprockets through a mechanical friction drive.
ENGINE:
14.5 HP Briggs & Stratton Intek, 4-Cycle, Single Cylinder,
Overhead Valve, Air-Cooled, Gasoline, Vertical Shaft with
Cast Iron Cylinder, AVS (Anti-Vibration System), Pressure
Lube & Filter.
STARTING SYSTEM:
Electric by key switch operation with safety interlock
blade drive.
TIRES:
Front
11 x 4.00-5 ribbed tread.
Rear
18 x 8.50-8 Turf Trac R/S
RECOMMENDED
Front
16-21 PSI
TIRE PRESSURE:
Rear
8-14 PSI
CAPACITIES:
Fuel
2.4 gallons total
Engine 1.5 quarts oil
DIMENSIONS:
Width 47 outside rear wheel measurement
Height 42 to top edge of seat
Length 72 hitch tab to front bumper
Weight 520 lbs.
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE