Naim Audio UnitiServe - Manual (Page 2)

UnitiServe-SSD Quick Start Guide English
Introduction
The UnitiServe-SSD is a CD-ripping hard disk player and server. It incorporates no built-in storage
but requires external network storage (a NAS drive) to be connected and configured before it can
be used. Configuring a NAS drive is described in Section 2 of this guide.
1 Install and Connect
• Install your UnitiServe-SSD on an equipment stand or rack intended for the purpose.
• Identify the UnitiServe-SSD rear panel Digital Output , Network and Power Input sockets. Use a
standard ethernet cable to connect the Network socket to a network router with a known working
internet connection.
Conventional wired network connection is strongly recommended for the most consistent and secure
UnitiServe-SSD operation. Ethernet-over-mains hardware may be used and provides a simple and
convenient method of home network connection. However, the presence of network data on the
mains supply may compromise overall audio system sound quality.
• If your UnitiServe-SSD is to be connected directly to a local audio system, connect one of the
Digital Output sockets (BNC coaxial or TosLink optical) to an audio system digital input.
• Connect the supplied External Power Supply to the UnitiServe-SSD rear panel Power Input socket
and to a mains power outlet.
2 Switch On and Set Up
• Ensure that the network router, NAS drive and peripheral audio equipment are connected,
switched on and working. Switch on the UnitiServe-SSD using the rear panel Power Switch . The
UnitiServe-SSD front panel logo will flash as the unit starts up. It is ready for use when the logo
illuminates continually.
• UnitiServe-SSD can be controlled via a Flash enabled web browser running on a computer
connected to the network.
To set up web browser control, open the browser, type the unique “name” of the UnitiServe-SSD
into the browser address field and press the “return” key. The UnitiServe-SSD name is the last four
characters of the MAC address (excluding the colon separators) printed on the UnitiServe-SSD rear
panel, preceded by
NSSRV A typical name would be NSSRV5E6F. Depending on the web browser,
you may need to type “http://” immediately before the UnitiServe-SSD name.
Full installation and operational information can be found in the UnitiServe-SSD Reference Manual
included on the CD packed with the product, or available at www.naimaudio.com
power input
power
switch network
digital audio
output (coaxial)
digital audio
output (optical)
Note: UnitiServe-SSD is
configured when shipped not
to require any network setup
but to connect to a network
automatically. However, if
your UnitiServe-SSD has been
previously used, its network
configuration may have been
altered, leaving it unable to
connect automatically. Refer
to the Reference Manual or
contact your retailer if this
appears to be the case.
Note: Alternative UnitiServe-
SSD control interfaces, such
as a remote handset or mouse
and VGA screen, a USB/
VGA touch screen, the Naim
DTC Windows application,
or iPad, iPhone or iPod touch
apps are described in the
Reference Manual.
Note: Ensure that the unit
has adequate ventilation. The
ambient temperature in the
vicinity of the unit should not
exceed 35°C.