DeLonghi TRN - Manual (Page 3)

3
BE CAREFUL
Operate the heater in upright position only. Any other position
could create hazardous situations!
1. LOCATION
Place the heater on the floor beneath the coldest window in the room or any desired location.
Your heater will minimize the effect of cold drafts.
The heater must not be located immediately below a socket-outlet.
Do not use this radiator in rooms having a surface area less than 45 sq. ft (4 m
2) .
2. CONNECTION
The radiator must be connected to a properly polarized A/C 110/120 V household outlet in
perfect working conditions.
Keep loose clothing or bedding, furniture and flammable material away from the wall outlet
where the heater plug is fitted in.
3. GROUND FAULT INTERRUPTION SAFETY DEVICE (GFI PLUG)
This device provides protection against electric shock due to ground
fault currents by automatically shutting off the power. To test the ope-
ration of the GFI plug switch the heater ON at either the 1 or 2 setting.
Press the TEST button on the GFI plug device attached to the plug
end of the line cord. The heater and fan should stop operating and the
Power Light should turn off. Press the RESET button on the GFI plug
device to resume normal operation of the heater. This device should not be used as on
ON/OFF operation switch.
“CAUTION: ALTHOUGH THIS DEVICE IS PROVIDED WITH PROTECTION WHICH
REDUCES THE RISK OF ELECTRIC SHOCK, THIS PRODUCT SHOULD NEVER BE USED
CARELESSLY NEAR WATER.”
4. SWITCHING ON TWO-SWITCH MODELS
Turn thermostat clockwise to the maximum position. Switch on both switches. The lights on
the switches remain on independently from of the cycling of the thermostat. When the room
reaches the desired temperature, turn the thermostat knob clockwise very slowly and carefully
until you hear a “click”. This will automatically set your unit to cycle on and off at that desired
heat setting. (For timer instructions, see point 5)
Note: It will normally require approx.15 minutes to reach operating temperature.
With pilot lights ON, the heater is ON!
POWER ECONOMIZER
For more economical use, the Min. or Med. Watt
switches may be used individually, after unit has
reached the operating temperature.
ON/OFF Switches
700
WATTS
800
WATTS
HOW TO USE
GB/E 4-06-2004 15:33 Pagina 3