Dymo H-1266 - Manual (Page 5)

H-1266
PAGE 5 OF 10 0808 IH-1266
4
3. Connecting your LabelWriter Printer
NOTE Do not connect the printer to your computer
until instructed to do so during the software
installation.
To connect the cables
1 Plug the power cord into the power adapter.
See Figure 4.
2 Plug the power adapter into the power connector
on the bottom of the printer. See Figure 5.
3 Plug the other end of the power cord into a
power outlet.
4 Plug the USB cable into the USB port on the
bottom of the printer. See Figure 5.
5 Insert the power and USB cables through the
cable channels and set the printer down.
NOTE DO NOT CONNECT the other end of the USB cable to
your computer until asked to do so during the software
installation.
6 When prompted by the software installer, plug the USB
cable into a USB port.
Power Adapter
Power Cord
Figure 4
Figure 5
USB Power
Cable
channels
Figure 6