Ryobi P580 - Manual (Page 8)

8 — English
ASSEMBLy
wARNiNG:
Do not use cutting wheels rated less than the no load
speed of this tool. Failure to heed this warning could
result in personal injury. Do not use wheel with cracks,
gaps, or teeth.
wARNiNG:
Do not use toothed or segmented wheels. Use only
continuous rimmed diamond wheels suited for masonry
materials.
iNSTALLiNG cUTTiNG whEEL
See Figure 3, page 13.
 Remove the battery pack from the saw.
 Remove the wheel wrench (5 mm hex key) from the stor-
age area.
 Depress the spindle lock button and remove the wheel
screw and outer wheel washer.
NOTE: Turn the wheel screw clockwise to remove.
cAUTiON:
To prevent damage to the spindle or spindle lock, always
allow motor to come to a complete stop before engaging
spindle lock.
NOTE: Do not run the saw with spindle lock engaged.

Wipe a drop of oil onto the inner wheel washer and outer
wheel washer where they contact the wheel.
wARNiNG:
If inner wheel washer has been removed, replace it before
placing cutting wheel on spindle. Failure to do so could
cause an accident since wheel will not tighten properly.
 Replace the outer wheel washer.
 Depress the spindle lock button, then replace the wheel
screw. Tighten the wheel screw securely by turning it
counterclockwise.
 Return the wheel wrench to the storage area.
NOTE: Never use a cutting wheel that is too thick to allow
the outer wheel washer to engage with the flats on the
spindle.
wARNiNG:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
wARNiNG:
Do not install battery until assembly is complete. Failure
to comply could result in accidental starting and possible
serious personal injury.
ATTAchiNG GRAviTy FEEd wATER BOTTLE
See Figure 2, page 13.
The gravity feed water bottle has a built in air vent that equal-
izes pressure and allows water to flow more freely.

Remove the battery.
 Unscrew the nozzle assembly.

Fill water bottle to desired level. Do not overfill.
 Replace nozzle assembly.
 Hold water bottle so that nozzle faces down.
NOTE: Water will not escape the bottle unless the tip of
the nozzle is depressed.
 Insert the water bottle as shown. Gently press down on
the bottle until it clicks into place.
 To remove water bottle, depress the water bottle release
button.
NOTE: For dry cutting, leave water bottle installed to prevent
dust and debris from clogging the water supply system.
cAUTiON:
Water bottle is designed for water only. Use of any other
fluid may cause damage to the tool.
wARNiNG:
A 4 in. wheel is the maximum wheel capacity of the saw.
Also, never use a wheel that is too thick to allow outer
wheel washer to engage with the flat on the spindle.
Larger wheels will come in contact with the wheel guards,
while thicker wheels will prevent wheel screw from se-
curing wheel on spindle. Either of these situations could
result in a serious accident.