Ryobi TC400 - Manual (Page 9)

9 — English
ASSEMBLY
UNPACKING
This product requires assembly.

Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
PACKING LIST
Wet/Dry Tile Saw
4 in. Cutting Wheel
Blade Wrenches (2)
Water Supply Kit
Operator’s Manual
WARNING:
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
ATTACHING WATER SUPPLY KIT
See Figure 4, page 15.
The water supply must come from a fresh water main. NEVER
turn the water supply on high. The water supply valve provides
a convenient on/off for starting and stopping the water flow
onto the cutting wheel.

Unplug the saw.
 Attach the water supply kit to the saw as shown using
the screw provided. Tighten securely.
 With the faucet turned completely off, attach the faucet
adaptor to a garden hose or outdoor faucet.
 Once the cutting wheel is installed, the tile saw is ready
to be used.
NOTE: For dry cutting, it is not necessary to install the water
supply kit.
WARNING:
A 4 in. wheel is the maximum wheel capacity of the saw.
Also, never use a wheel that is too thick to allow outer
blade washer to engage with the flat on the spindle.
Larger wheels will come in contact with the wheel guards,
while thicker wheels will prevent blade screw from se-
curing wheel on spindle. Either of these situations could
result in a serious accident.
WARNING:
Do not use cutting wheels rated less than the no load
speed of this tool. Failure to heed this warning could
result in personal injury. Do not use wheel with cracks,
gaps, or teeth.
WARNING:
Do not use toothed or segmented wheels. Use only
continuous rimmed diamond wheels suited for masonry
materials.