Ryobi RTS30 - Manual (Page 16)

16
TO ATTACH THE WHEEL ASSEMBLY
See Figure 6.

Locate the wheels, bolts, flat washers, sleeves, and nuts.
 Slide a flat washer on a bolt then slide the bolt / washer
into the wheel hole of a wheel.
 Hold a sleeve inside the leg tube aligning the sleeve ends
with holes in the leg tube.
 Slide the bolt/wheel/washer combination into the holes
and through the leg tube and sleeve.
 Place a flat washer on the end of the bolt and secure
using a nut.
 Repeat with the second wheel assembly.
TO ATTACH THE LEG
See Figure 7.

Stand the table saw on end as shown in figure 7.
 Slide the leg in the leg stand tubes aligning the holes in
both tubes.
 Insert a carriage bolt into the hole (from the outside toward
the inside). Finger tighten using a nut.
 Repeat for remaining legs.
NOTE: Once the leg stand is in an upright position (see page
17) and the saw is level, securely tighten the nuts. Place the
saw on level ground and verify the saw’s stability before use.
TO INSTALL THE HANDLE
See Figure 8.

Hold the nut securely and turn the screw counter-
clockwise to remove the nut completely.
NOTE: Do not remove the screw from the handle or the
washer from the end of the screw.
 Place the nut into the recessed hole on the back of the
height/bevel adjusting handwheel and hold in place.
 Slide the handle, screw, and washer into the hole on the
height/bevel adjusting handwheel.
 Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
ASSEMBLY
Fig. 8
NUT
HEIGHT/BEVEL
ADJUSTING
HANDWHEEL
SCREW
HANDLE
Fig. 6
Fig. 7
NUT
CARRIAGE
BOLT
LEG STAND
TUBE
NUT
FLAT
WASHER
SLEEVE
BOLT
WHEEL
FLAT
WASHER