Ryobi BTS211 - Manual (Page 26)

26
OPERATION
 Retighten hex nut, securing eccentric screw and quick-
stop.
 Check your work. If the quick-stop is not at zero degrees,
repeat above steps.
wARNING:
To reduce the risk of injury, always make sure the rip fence
is parallel to the blade before beginning any operation.
TO SET THE RIP FENCE SCALE INDICATOR
TO THE bLADE
See Figure 29.
Begin with the blade at a zero angle (straight up).
 Unplug the saw.
 Raise the blade guard.
 Loosen the rip fence by lifting the locking lever.
 Using a framing square, set the rip fence 2 in. from the
blade tip edge.
 Loosen the screw on the scale indicator and align with
the 2 in. mark as shown.
 Tighten the screw and check the dimension and the rip
fence.
TO USE THE RIP FENCE
See Figure 30.
 Place the rear lip on the rear of the saw table and pull
slightly toward the front of the unit.
 Lower the front end of the rip fence onto the guide
surfaces on top of the front rail.
 Push the locking lever down to automatically align and
secure the fence.
Check for a smooth gliding action. If adjustments are needed,
see
To Check the Alignment of the Rip Fence to the blade
in the Adjustment section of this manual.
Fig. 30
rear liP
riP Fence
locKinG
leVer
saW
taBle
2 in.
Front
rail locKinG
leVer
Blade
riP
Fence
2 in.
marK
scale
scale
indicator
Fig. 29
quicK
stoP
Fig. 28