Ryobi RY34007 - Manual

WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
Go to www.ryobitools.com and register your new tool on-line. For any questions about
operating or maintaining your product, call the Ryobi ® Help Line! Your Product has been
fully tested prior to shipment to ensure your complete satisfaction. Troubleshooting tips
are also available in your operator’s manual. For additional registration instruction, refer
to operator’s manual.
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.
Later uses: Check engine lubricant level and add lubricant if needed.
Carefully pour fuel into the tank. Avoid spillage.
Immediately replace fuel cap and hand tighten.
Wipe up any fuel spillage.
PRIME
press the PRIMER BULB 10 times
slowly.
SET
CHOKE lever to “ FULL CHOKE “
position. Do not squeeze throttle trigger.
Press the PRIMER BULB 10 times
slowly. Set choke lever to RUN. Pull
starter grip until the engine runs.
DEPRESS the “STOP” switch to the STOP position
Warm Engine:
After 10 seconds,
SET
CHOKE lever to RUN
position.
Cold Engine:
To Stop:
With throttle at idle,
PULL
starter grip sharply
until engine runs. (Max 3 times)
• If 60°F or lower, continue to pull starter grip until
engine runs.
• If above 60°F, set CHOKE lever to “HALF
CHOKE” and pull starter grip until engine runs.
ENGINE STARTING PROCEDURE
1
2
3
4
4 5
5
2
4
1
6
3
5
6
LUBRICANT
1 GALLON
GAS
10x
HALF
CHOKE
RUN
10x
RUN
FULL
CHOKE
RUN
HALF
CHOKE
NOTICE
Do not use E15 or E85 fuel (or fuel
containing greater than 10% ethanol) in
this product. It is a violation of federal
law and will damage the unit and void
your warranty.
CALL
1-800-860-4050
www.ry
obitool
s.com
990000697
8-6-13 (REV:01)