Ryobi P2200 - Manual (Page 13)

9 — English
WARNINg:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNINg:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNINg:
Never use blades, flailing devices, wire, or rope on this
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
This product will accept Ryobi One+ 18 V lithium-ion battery
packs and Ryobi One+ 18 V nickel-cadmium battery packs.
For complete charging instructions, refer to the Operator’s
Manuals for your Ryobi One+ battery pack and charger
models.
notice:
This product is designed to be powered by either a Ryobi
One+ 18V battery pack (DC mode) or by electric power
(AC mode). The power mode is selected by sliding the
power selection door to the desired power source and
either installing an approved battery pack or extension
cord as described in this manual.
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps, etc.
Tighten securely all fasteners and caps and do not operate
this product until all missing or damaged parts are replaced.
Please call 1-800-860-4050 or contact an authorized service
center for assistance.
ApplICATIoNs
You may use this product for the purpose listed below:

Trimming grass and weeds from around porches, fences,
and decks.
WARNINg:
Always remove the battery pack or disconnect the tool
from the power supply and keep hands clear of the lock-
out button and switch trigger when carrying, transporting,
assembling parts, making adjustments, cleaning, or when
not in use. Following these instructions will prevent ac-
cidental starting that could cause serious personal injury.
WARNINg:
Make sure the latches on the battery pack snap in place
and the battery pack is fully seated and secure in the
trimmer battery port before beginning operation. Failure
to securely seat the battery pack could cause the battery
pack to fall out, resulting in serious personal injury.
To INsTAll bATTERy pACk
See Figure 5.
 Slide power selection door over power receptacle until it
clicks into place.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
To REMoVE bATTERy pACk
See Figure 5.

Depress the latches on each side of the battery pack.
 Remove the battery pack.
sTARTINg/sToppINg ThE TRIMMER (DC)
See Figures 5 - 6.
To start:

Slide power selection door over power receptacle until it
clicks into place.
 Insert battery.
 Press and hold the lock-out.
 Depress the switch trigger.
To stop:

Release the switch trigger to stop the motor.
 Upon release of the switch trigger, the lock-out will
automatically reset to the locked position.
opERATIoN