Vitek VT-3625 - Manual (Page 6)

seconds, the retune mode activates.
RETUNE L: Sets the TA search mode delay to
90 seconds.
RETUNE S: Set the TA search mode delay to 30
seconds.
Controlling the frequency raising function (2)
Upon pressing the SEL button for more than 2
seconds, the settings mode for this function
activates.
The LOUD ON/OFF mode is chosen by rotating
the VOL knob. The bass and treble characteris-
tics will be amplified.
ESP mode (2)
Upon pressing the SEL button for more than 2
seconds, the settings mode for the electronic
shock protection function (ESP) will activate: 12
seconds or 45 seconds.
BEEP mode (2)
Upon pressing the SEL button for more than 2
seconds, the sound accompaniment mode is
activated.
BEEP ON: Each button press will be accompa-
nied by an audible beep.
SEEK mode (2)
Upon pressing the SEL button for more than 2
seconds, you can change the settings of the
automatic SEEK mode.
SEEK 1: When the SEEK 1 option is selected,
the automatic scanning of frequencies stops
when a station is found, even if the user is still
holding down the SEEK button.
SEEK 2: The automatic scanning of frequencies
does not stop when a station is found if the user
is till holding down the SEEK button. Upon
releasing the SEEK button, the automatic fre-
quency search will stop when the next station is
found.
STEREO/MONO (2)
Upon pressing the SEL button for more than 2
seconds, the sound settings (stereo or mono)
mode is activated.
When an FM station’s signal strength is weak
and contains a lot of static, you can increase
reception quality by switching to mono mode.
LOCAL/DX (2)
Upon pressing the SEL button for more than 2
seconds, the local or distant radio station set-
tings mode is activated.
Using the “Local” setting in areas with strong
signals allows the radio to only stop on stations
with strong signals during manual tuning (the
LOC symbol appears on the display). Activate
the “Distant” setting in areas with weak radio
signals in order to hear all the available stations.
Front panel backlight (2)
Upon pressing the SEL button for more than 2
seconds, you can choose between blue or red
backlights.
Last volume level /settings (2)
Upon pressing the SEL button for more than 2
seconds, the volume setting mode is activated.
VOL LAST: When turning on the radio, the vol-
ume will remain at the same level as when last
used.
VOL ADJ: The volume will be adjusted to a
“starting level” (the user can adjust the volume
later) each time the unit is turned on.
4. Station presets (1,2,3,4,5,6)
(A) Radio mode:
When pressed momentarily, these buttons tune
the radio directly to the preset station. When
ENGLISH
6
3625_4l.qxd 29.03.05 16:39 Page 6