Ryobi RY13015 - Manual

990000058
3-30-12 (REV:01)
FRONT
CALL
1-800-860-4050
www.ryobitools.com
3
Carefully pour fuel into the tank. Avoid spillage. Immediately replace
fuel cap and hand tighten. Wipe up any fuel spillage.
1 GALLON
GAS
M ove the choke lever to the START position and then immediately back
to the RUN position. Pull the starter grip and rope until the engine starts.
NOTE: This will set the carburetor to a fast idle setting for easier starting.
10x
6
1
2
4
5
7
LUBRICANT
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for reading the
operator’s manual. To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
3
6
2
To Stop:
First time use only: Pour entire contents of ONE engine lubricant bottle
into oil fill hole using the funnel provided.
Press the on/stop switch in the ON ( I ) position.
Press the primer bulb 10 times or until fuel appears.
Cold Engine:
8
10
Flip the choke lever to START position.
Stand beside the trimmer and place your right hand on the
handlebar and your foot on the frame as shown.
Pull starter grip and rope sharply with your left hand until engine attempts to run.
Pull starter grip and rope until engine runs.
NOTE: If the engine dies, set the choke lever to the RUN position and
pull the starter grip and rope until the engine starts.
NOTE: If engine does not start, return to step 5 and repeat.
Press the on/stop switch in the STOP ( O ) position.
1
7
5
4
9
START
Flip the choke lever in the RUN position.
Warm Engine:
RUN
START
9
9
RUN
9
Squeeze throttle trigger to operate.
8