Ryobi RY34421 - Manual

RYOBI ART WORK
Art Part No. : 987000-859 Rev. 01
Where Used : 987000-857
Refer to Drawings for Dimensions.
987000-859
12-23-09 (REV:01)
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
Cold Engine:
Warm Engine:
To Stop:
DEPRESS the “STOP” switch to the STOP position
Carefully pour fuel into the tank. Avoid spillage. Immediately replace
fuel cap and hand tighten. Wipe up any fuel spillage.
PRIME
press the PRIMER BULB 10 times slowly.
DO NOT squeeze TRIGGER LOCK or THROTTLE TRIGGER until
engine starts and runs.
SET
CHOKE lever to " FULL CHOKE " position.
With throttle at idle,
PULL
starter grip
sharply until engine attempts to run.
1 GALLON
GAS
After 10 seconds,
SET
choke lever to RUN position.
10x
10x
RUN
RUN
5
1
2
3
4
6
8
SET
CHOKE lever to " HALF CHOKE " position.
PULL
starter grip until the engine runs.
7
LUBRICANT
ENGINE STARTING PROCEDURE
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
First time use only: Pour entire contents of ONE engine lubricant bottle into oil fill hole using the funnel provided.
Later uses: Check engine lubricant level and add lubricant if needed.
For any questions about operating or maintaining your product, call the Ryobi ® Help Line!
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
For additional registration instruction, refer to operator’s manual.
CALL
1-800-860-4050
www.ry
obitool
s.com
Press the PRIMER BULB 10 times slowly.
Set choke lever to RUN.
Pull starter grip until the engine runs.
1
5
2
3
4
6
8 7
FULL
CHOKE
HALF
CHOKE
FULL
CHOKE
RUN
HALF
CHOKE