Electrical, Features – Ryobi CFS1501 User Manual
Page 7
7 — English
Before using any extension cord, inspect it for loose or
exposed wires and cut or worn insulation.
**Ampere rating (on product data plate)
0-2.0
2.1-3.4
3.5-5.0 5.1-7.0 7.1-12.0 12.1-16.0
Cord Length
Wire Size (A.W.G.)
25'
16
16
16
16
14
14
50'
16
16
16
14
14
12
100'
16
16
14
12
10
—
**Used on 12 gauge - 20 amp circuit.
NOTE: AWG = American Wire Gauge
ELECTRICAL
WARNING:
Keep the extension cord clear of the working area.
Position the cord so that it will not get caught on
lumber, tools, or other obstructions while you are working
with a power tool. Failure to do so can result in serious
personal injury.
WARNING:
Check extension cords before each use. If damaged
replace immediately. Never use the product with a
damaged cord since touching the damaged area could
cause electrical shock resulting in serious injury.
PRODUCT SPECIFICATIONS
Sanding Pad Length ...................................................................................................................................................5-1/2 in.
No Load Speed .................................................................................................................................................12,000 r/min.
Orbit Diameter ............................................................................................................................................................. 1/16 in.
Input ................................................................................................................................... 120 Volts, 60 Hz, AC only, 1 Amp
Weight ......................................................................................................................................................................... 2.6 lbs.
KNOW yOUR COMPACT FINISHING SANDER
See Figure 1, page 12.
The safe use of this product requires an understanding of
the information on the product and in this operator’s manual
as well as a knowledge of the project you are attempting.
Before use of this product, familiarize yourself with all
operating features and safety rules.
CIRCULAR SANDING ACTION
The oscillating action of your sander produces very quick,
small circular motion of the sanding pad. The motion is
ideal for producing a fine finished grain or, when using the
scrubbing pad, removing light rust, paint and other build up
from the work surface.
DUST COLLECTION BAG
The dust bag attaches to the sander and keeps dust to a
minimum.
PAPER PUNCH
The paper punch template punches sandpaper for proper
fit and alignment.
QUICK CHANGE HOOK-AND-LOOP PAD
The hook-and-loop design allows for quick change of sanding
sheets and scrubbing pads. It also enables you to easily
clean and reuse them.
SWITCH
This tool is equipped with a simple switch control located
near the front of the motor housing.
TRI-FLEX PAD DESIGN
The top two-thirds of each sanding sheet is a detachable
triangle that can be rotated to extend sandpaper life and
promote even wear.
FEATURES