Ryobi RY52604 - Manual

ENGINE STARTING PROCEDURE
RYOBI ART WORK
Art Part No. : 987000546 Rev. 000
Where Used : 987000546
Refer to Drawings for Dimensions.
987000546
10-28-08 (REV:00)
Material: 60lb. Stock Paper.
Color: Lift-off Bright Pink.
FRONT
PRESS and HOLD switch until
engine stops
To Stop:
For any questions about operating or maintaining your product, call the Ryobi Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are also available in your operator’s manual.
Go to www.ryobitools.com and register your new tool on-line.
For additional registration instruction, refer to operator’s manual.
CALL
1-800-860-4050
www.ry
obitool
s.com
®
1
50:1 Ratio = Mix 2.6 oz 2-cycle lubricant with
1 gallon of fresh gasoline in separate gas
container. SHAKE. Pour into fuel tank.
PRIME
press the PRIMER BULB 7 times.
DO NOT squeeze TRIGGER LOCK or THROTTLE TRIGGER until
engine starts and runs.
SET
START lever to " START " position.
PULL
rope until engine starts.
1 GALLON
GAS
2
3
4
5
6
Wait 6-10 seconds, squeeze trigger and release to run.
x7
2.6
oz.
START
RUN
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
1
6
2
3
4
5