Ryobi FPR2000 - Manual

how to get started
WARNING: This How To Get Started sheet is
not a substitute for reading the operator’s manual.
To reduce the risk of injury or property damage, user
must read and understand operator’s manual before
using this product.
Place plastic paint container lid onto the paint can.
Insert paint can into unit and lock handle closed.
Push dual control lever to the left to choose one person
operation.
Attach the paint tube to the quick-connect main outlet on unit.
Attach the other end of the paint tube to the quick connect outlet on
the handle.
Attach roller to handle.
Plug in the unit, place the forward/reverse switch in the forward
position.
Open the variable flow control valve, then squeeze and hold the
trigger on the roller handle to get paint flowing through the paint
tube.
Test the roller on a scrap surface before beginning.
Adjust the variable paint flow valve for desired paint coverage.
When finished, clean all parts before storing.
1
2
3
4
5
6
For detailed instructions on how to
perform any of the steps at right,
please see the operator’s manual.
7
8
3
5
6
9
For set-up when using two-person operation,
please see the operator’s manual.
10 7
10
8
2
4
9
1
REVERSE
FORW ARD
988000-048
3-29-10 (REV:02)