Ryobi YG250FS - Manual (Page 7)

7 — English
DANGER:
Do not use oxygen, combustible gases, or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1. Failure to do so could
result in fluids entering your eyes resulting in possible
serious injury.
WARNING:
Disconnect the tool from the air supply before leaving the
work area, moving the tool to another location, or handing
the tool to another person. Failure to do so could result
in serious personal injury.
APPLICATIONS
You may use this product for the purpose listed below:

Finish and Trim (Interior and exterior)
 Door & Window Casing
 Door Jambs
 Baseboard
 Crown Molding
 Cabinetry
 Cap and Shoe Molding
 Molding
 Staircases
 Door and Window Trim
 Chair Rail
 Brickmold
 Hardwood Flooring
 Paneling
 Furniture
WARNING:
Always wear eye protection. Eye protection does not fit all
operators in the same way. Make sure the eye protection
chosen has side shields or provides protection from flying
debris both from the front and sides.
OPERATION
PREPARING THE TOOL FOR USE
See Figure 1, page 14.
Under normal use conditions, the tool should be lubricated
before connecting the tool to an air supply. Add air tool oil
into the air fitting on the tool once daily with minimal use,
or twice a day with heavy use. Only a few drops of oil at a
time is necessary. Too much oil will only collect inside the
tool and will be noticeable in the exhaust cycle.
Before connecting the tool, check the air compressor
gauge to be sure it is functioning within the proper range of
70-120 psi.
NO-MAR NOSEPIECE
See Figure 2, page 14.
The no-mar nosepiece prevents marring and denting when
using the tool on softer woods.
WARNING:
Disconnect the tool from the air supply before removing
or replacing the no-mar nosepiece. Failure to do so could
result in serious personal injury.
The no-mar nosepiece can be removed by pulling it down
and away from the nose. To replace the no-mar nosepiece
fit it into place over the workpiece contact and push up at
the back to reseat.
ADJUSTING THE EXHAUST
See Figure 3, page 14.
The adjustable exhaust on the end cap of the tool allows
the operator to direct the exhaust according to operator
preference. To adjust, turn the exhaust cap until the exhaust
blows in the desired direction.
WARNING:
Disconnect the tool from the air supply before leaving the
work area, moving the tool to another location, or handing
the tool to another person. Failure to do so could result
in serious personal injury.
CONNECTING THE TOOL TO AN AIR SUPPLY
See Figure 4, page 14.
DANGER:
Do not use oxygen, combustible gases or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
This tool is designed to operate on clean, dry compressed air
at regulated pressures between 70 and 120 psi. The correct
air pressure is the lowest pressure that will do the job.