Pontiac 2006 Gto - Manual (Page 235)

8. Turn the vertical aiming screw (A) until the
headlamp beam is aimed to the horizontal tape line.
If you turn it clockwise, it will raise the beam and
if you turn it counterclockwise, it will lower the beam.
The top edge of the cut-off should be positioned
at the bottom edge of the horizontal tape line.
9. Repeat Steps 7 and 8 for the opposite headlamp.
Bulb Replacement
For the proper type of replacement bulbs, see
Replacement Bulbs on page 5-49 .
For any bulb changing procedure not listed in this
section, contact your dealer.
Halogen Bulbs
{ CAUTION:
Halogen bulbs have pressurized gas inside and
can burst if you drop or scratch the bulb. You or
others could be injured. Be sure to read and
follow the instructions on the bulb package.
Headlamps
Driver’s Side
To replace the driver’s side headlamp bulbs, first do the
following:
1. Open the hood. See Hood Release on page 5-11
for more information.
Passenger’s Side Shown
5-45
2006 - Pontiac GTO Owner Manual