Vizio VSB200 - Manual (Page 10)

VIZIO VSB200 User Manual
10
www.VIZIO.com
Inst Inst Inst Installing alling alling alling the the the the Batter Batter Batter Battery y y y in the Remote Control in the Remote Control in the Remote Control in the Remote Control
Turn the remote control over. Press inward to release the lock (1), and at the same time, slide the battery
holder out of the remote with your fingernail (2). Remove the protective plastic sheet by pulling straight
out from the remote.
The supplied CR2025 Lithium Button Battery should match the (+) symbol on the battery with the (+)
symbol on the battery holder. Re-insert the battery cover in the same orientation.
Precautionary Tips for Inserting the Batteries:
Only use the specified battery.
Inserting the battery incorrectly may also result in
damage to the remote control.
Dispose of the battery in accordance with local laws
and regulations.
Keep the battery away from children and pets.
Remote Control Range Remote Control Range Remote Control Range Remote Control Range
Point the remote control at the remote control sensor to transmit the commands.
Do not place any obstacles between the remote control and the receiver window. The effective range of
the remote control is approximately 30 feet (10 meters) from the front of the receiver window, 30° to the
left and right, 20° up and down.
VIZIO Remote Control VIZIO Remote Control VIZIO Remote Control VIZIO Remote Control Precautions Precautions Precautions Precautions
The remote control should be kept dry and away from heat sources. Avoid humidity.
If the HD Sound Bar responds erratically to the remote control or does not respond at all, check the
battery. If the battery is low or exhausted, replace it with a fresh battery.
When not using the remote control for a long period of time, remove the batteries.
Do not take the battery apart, heat it, or throw it into a fire.
Do not subject the remote control to undue physical stress, such as striking or dropping it.
Do not attempt to clean the remote control with a volatile solvent. Wipe it with a clean, damp cloth.
Cleaning the Housing and Remote Control Cleaning the Housing and Remote Control Cleaning the Housing and Remote Control Cleaning the Housing and Remote Control
If the housing or remote control is seriously contaminated, use a soft cloth moistened with diluted neutral
cleaner to clean the display. Wring water out of the cloth before cleaning to prevent water from
penetrating into the housing. Wipe with a dry cloth after cleaning.
Changing Volume Lock Changing Volume Lock Changing Volume Lock Changing Volume Lock (when using a VIZIO Universal remote (when using a VIZIO Universal remote (when using a VIZIO Universal remote (when using a VIZIO Universal remote
with the Sound Bar) with the Sound Bar) with the Sound Bar) with the Sound Bar)
VIZIO Universal remotes are normally set to control the volume of the TV, even when one of the other
programmable devices is selected. The remote control can be set to control the device volume, the
Sound Bar in this case, by changing the Volume Lock.
To change the volume lock:
1. Press and release the AUDIO button.
2. Press and hold the SETUP button until the LED on the remote flashes twice.
3. Press 9 9 3. The LED flashes twice.
4. Press VOL - The LED flashes four times. The Sound Bar volume will now be controlled using
VOL+/VOL- while in the AUDIO device mode, and the TV, Cable/Satellite or DVD volume when in
TV, Cable or DVD modes.