Wunder Audio CM50 - Manual (Page 2)

longer be used.
The microphone must be operated only with the supplied
cable. Since hazardous voltages are generated by the PSU that
can result in injury or death, always ensure that the
microphone cable used is undamaged. Damaged cables must
no longer be used.
Operation
The CM50 is equipped with a 8-pin Tuchel connector that plugs into
the base of the microphone and screws tight. Always make sure that
the PSU is switched off when plugging the microphone connector
into the microphone and PSU.
Polar pickup pattern
The capsule of the CM50 is equipped with a small diaphragm and
mounted inside a perspex sphere. It operates as an omni-directional
pressure transducer. The frequency response of the microphone
rises at the high frequency end evenly by about 5 dB without
becoming too directional. With a diffuse sound field, this results in
an almost linear frequency response from 40 Hz to 15 Khz.
How to mount the microphone
A special Yoke mount/stand adapter is provided and should always
be used to mount the microphone on floor stands or booms.
To mount the microphone, fully unscrew the knurled knob on the
side of the metal belt. Place the microphone into the metal belt
making sure that the white jewel on the front of the microphone is
centered into the center hole on the yoke belt. Make sure that the
there is no black rubber grommet in the center hole on the belt, if it
is present, remove it.
Close the metal belt carefully around the microphone making sure
that the leading edge of the metal belt does not scratch the body of
the microphone. Screw the knurled knob clockwise to tighten the