Wunder Audio CM12 - Manual (Page 3)

with standard thread sizes. It may also be swiveled against the
stand axis to suit the recording angle.
Powering of the Microphone
The required PSU is included with the microphone. It is clearly
marked and should be quite obvious by connector type and size
how to connect the microphone to the power unit with the supplied
CM12 microphone cable. The audio signal may be taken from the
transformer-balanced power unit by a conventional audio cable with
standard XLR-type connector.
After connection of the microphone, the power supply, and the AC
line, the main switch may be switched on. Operating condition will
be indicated by the power lamp.
The warm-up time of the CM12 is approximately one minute. When
your CM12 is new, a 24-hour burn-in period is recommended.
The CM12’s tube will “break in” over a period of time enabling the
CM12 to sound subtly better over a period of time.
2. The CM12 Power Supply
This PSU supplies the microphone with the 6.3V filament voltage
and 120V plate voltage for the vacuum tube.
Prior to connecting the CM12 to AC power, check the AC voltage of
the power line you are going to connect to the CM12.
The CM12 PSU has an internal AC voltage selector switch.
To check the CM12 PSU AC voltage selector switch, first unplug the
AC cable (power plug) from the PSU.
Use a flat-blade screwdriver to unscrew the lid to the PSU and
remove.
You will see a small chrome toggle switch located inside the unit