DirecTV GRD33G2A - Manual (Page 52)

REFERENCE
50
After you program the remote to
control your TV, record your TV code
here for easy reference.
Programming the Remote Control
The DSS ® remote can be programmed to control most brands of
remote controllable televisions.
Programming the Remote to Control a TV
To determine whether the remote needs to be programmed,
turn the TV on, point the remote at the TV, and press the TV
button. Then press CHAN UP or DOWN to see whether the TV
responds to the remote commands.
Follow these steps to program your remote to control your TV.
1. Turn on the TV.
2. Look up your brand and code number(s) on the TV Code list
on page 51.
3. Press and hold the TV button.
4. Enter the three-digit code from the code list.
5. Release the TV button and press OFF•ON or CHAN UP/
DOWN to see if the TV responds to the remote commands. If
it doesn’t, try the next code listed for your brand.
6. Repeat these steps until the TV responds to the remote
commands.
Using the Remote Buttons to Control a TV
Once the remote has been programmed with the correct codes,
you are ready to use it to control your TV.
To operate the device:
1. Press the TV button to set the remote to control the TV.
2. Press OFF•ON to turn the TV off or on.
3. Use the remote buttons to control the TV.
This remote may not operate all
models of the brands that are
shown. Use the codes shown in this
manual, or on the sheet packed with
your remote.