Weston Multi-grain & Cereal Mill - Manual (Page 4)

1 Fill the Hopper with the material you intend to grind.
2. Position a bowl or plate under the Grinding Plates to catch the material as it is
being ground.
3. Slowly turn the Handle clockwise.
4. Inspect the material that has been ground.
NOTE: Depending on the type of material that is being ground and your personal
preferences, you may need to adjust the Pressure Screw to achieve your desired
results.
FOR COARSE GRINDING: Loosen the Wing Nut and turn the Pressure Screw counter
clockwise – this will increase the gap in the Grinding Plate, resulting in a coarser grind.
Then re-tighten the Wing Nut and resume grinding.
FOR FINE GRINDING: Loosen the Wing Nut and turn the Pressure Screw clockwise
– this will decrease the gap in the Grinding Plate, resulting in a finer grind. Then re-
tighten the Wing Nut and resume grinding.
GRINDING INSTRUCTIONS
• Always make sure the material you are grinding is completely dry.
Material that contains moisture will decrease the performance of the Mill.
• Turn the Handle at constant speed, try to avoid starting and stopping the Handle
while grinding.
• If the Mill becomes jammed and the Handle will not turn, briefly turn the Handle
counter-clockwise to remove jam. Resume normal grinding.
• Do Not fill the Hopper with more material than what you plan on grinding.
• Always make sure the Mill is securely attached to work surface before you start
grinding .
TIPS FOR EASY OPERATION
-4- -5-
1. Clamp the Main Body to the edge of a table or counter top. Make sure the
Rubber Protector Plate is positioned on the Foot to prevent damage to the work
surface.
NOTE: The maximum recommended thickness of the clamping surface should not
exceed 1½”.
2. Insert the Auger and Adjustable Grinding Plate into the Main Body.
3. Install the Shield with Grinding Plate Pressure Screw onto the Main Body.
4. Position the Rotating Thumbscrews into the slots in the Main Body and securely
tighten.
5. Set the Adjustable Grinding Plate Pressure Screw and securely tighten the
Wing Nut against the Shield.
6. Install the Handle onto the end of the Auger.
7. Secure Handle to the Auger using the Thumbscrew and attached Cap Washer.
8. Install Hopper onto the top of the Main Body.
ASSEMBLY INSTRUCTIONS
.
Before using for the first time, you must completely disassemble the Cereal & Grain
Mill and thoroughly clean all parts with hot water and dish detergent. Rinse with clean
water and dry thoroughly.
.
For cleaning between uses, simply brush away any left over material with a towel or
medium bristle brush.
.
DO NOT clean any parts of the Multi-Grain & Cereal Mill in a dishwasher.
CLEANING INSTRUCTIONS