Pulp regulator settings, Assembly instructions, Tips for safe and easy operation – Weston Manual Wheatgrass Juicer User Manual
Page 4: About wheat grass juice, Cleaning instructions disassembly instructions
• By adjusting the
Pulp Regulator up and down, you can determine how much juice
is extracted from the pulp. This setting is a personal preference and results can be
determined during the early stages of using your
Wheat Grass Juicer for the first
time.
• MORE EXTRACTION: Turn the
Pulp Regulator clockwise to move the
Regulator down and apply more pressure to the wheat grass as it is being
squeezed, resulting in more juice.
• LESS EXTRACTION: Turn the
Pulp Regulator counter-clockwise to
move the
Regulator up and apply less pressure to the wheat grass as it is being
squeezed, resulting in less juice.
PULP REGULATOR SETTINGS
-4-
-5-
ASSEMBLY INSTRUCTIONS
1. Securely clamp the
Juicer Body to the edge of a table or counter top. Make sure
the
Rubber Foot Protector is positioned on the Juicer Body Foot to prevent
damage to the work surface. NOTE: The maximum recommended thickness of
the clamping surface should not exceed 1 ½”
2. Insert the
Screen completely into the Juicer Body.
3. Position the
Auger in the Grinder Body, so it rests on top of the Screen.
4. Position the
Auger Retainer on the Juicer Body, until the end of the Auger
protrudes from the middle of the Auger Retainer.
5. Secure the
Auger Retainer to the Juicer Body using the two Thumbscrews
with Cap Washers.
NOTE: Before securing, make sure the Rubber Seal is properly positioned
between the
Juicer Body and Auger Retainer.
6. Install the
Handle onto the end of the Auger, securing with the Handle
Thumbscrew with Cap Washer.
7. Screw the
Pulp Regulator onto the end of the Juicer Body.
• Always make sure the material you are juicing is completely free of any hard
material that may cause damage to the
Screen and Auger.
• Turn the
Handle at constant speed.
• Try to avoid starting and stopping the
Handle while juicing.
• If the
Juicer becomes jammed, and the Handle will not turn, briefly turn the Handle
counter-clockwise to remove jam. Resume normal operation.
• Do Not fill the
Juicer Body with more material than what you plan on using.
• Always make sure the
Juicer Body is securely attached to work surface before you
start juicing.
TIPS FOR SAFE AND EASY OPERATION
Health-conscious individuals term wheat grass as one of the so-called “green foods”
that is valued as a great source of natural nutrients. In juice form, wheat grass contains
70% Chlorophyll, which is often referred to as the blood of plant life and most closely
resembles the molecules of human red blood cells. Chlorophyll has been shown to
produce an unfavorable environment for bacterial growth in the body and therefore
effective in increasing the body resistance to illness.
WHEAT GRASS JUICE CAN ALSO:
• Help to reduce high blood pressure, as it cleanses the bloodstream.
• Enhances the white blood cell count, strengthening the immune system.
• Alleviates anemia, as the chlorophyll raises the hemoglobin level of the blood.
• Supplies laetrile, which selectively destroys cancerous cells without harming normal
cells.
• Rubbed into scalp, reduces dandruff and restores the normal color to hair.
• Used as a mouth wash, relieves toothache and sore throat, and helps prevent tooth
decay.
• Is one of the richest sources of vitamins A, B, and C. It is an excellent source of
calcium, iron, magnesium, phosphorus, potassium, sodium, sulfur, cobalt, zinc, and
protein.
ABOUT WHEAT GRASS JUICE
.
Before using for the first time, you must completely disassemble the
Juicer and
thoroughly clean all parts with hot water and dish detergent. Rinse with clean water
and dry thoroughly.
.
DO NOT clean in a dishwasher.
CLEANING INSTRUCTIONS
DISASSEMBLY INSTRUCTIONS
1. Remove the
Handle Thumbscrew with Cap Washer and remove the Handle from
the
Auger.
2. Completely remove the two
Thumbscrews with Cap Washers and take off the
Auger Retainer.
3. Remove the
Auger from the Juicer Body.
4. Slide the
Screen out from the Juicer Body.
5. Turning counter-clockwise, remove the
Pulp Regulator.
6. Remove the
Rubber Foot Protector.