Operating instructions, Cleaning assembly – Weston Multi-Seed Grinder User Manual

Page 4

OPERATING INSTRUCTIONS

-4-

-5-

1. With the

Multi-Seed Grinder

secured to a work surface, place a bowl under the

Multi-Seed Grinder

mouth to catch ground seeds.

2. Place seeds into the hopper of the

Multi-Seed Grinder Body

3. While facing the

Auger end of the

Multi-Seed Grinder

, turn

Handle clockwise

to grind.

4. To change the coarseness of the grind, loosen or tighten the

Handle Screw.

5. Properly ground seeds should be fully crushed and loose with no trace of oil.

Prior to the first use and after each use, disassemble the

Multi-Seed Grinder

and

thoroughly wash each part in warm, soapy water. Rinse with clear water. Dry all parts

thoroughly before re-assembly or storage. Be sure apply a food safe silicone spray to

all metal parts.

This item is NOT dishwasher safe.

CLEANING

ASSEMBLY

1. Insert the

Auger into

the

Grinder Body.

2. Place the

Washer over

the threaded end of the

Auger.

3. Attach the

Handle to

the threaded end of the

Auger.

4. Screw the

Handle

Screw onto theend of the

Auger until it is snug.

5. Snap the

Rubber Foot

onto the

Grinder Body.

6. Open the

Clamp

Screw on the Grinder

Foot enough to fit to the

work surface. Be sure
the

Handle is able to turn

freely.

7. Tighten the

Clamp

Screw until the Multi-

Seed Grinder is tightly

secured to the work
surface.

Auger

Grinder Body

Washer

Handle

Screw

Rubber Foot

Clamp Screw

Grinder Foot