Volant FJ Cruiser Snorkel User Manual
Page 2
18740
1. Disconnect the negative battery cable.
2. Remove the engine cover.
3. Remove the factory MAF sensor.
4.
Remove the two bolts holding the resnator box in place.
5.
Remove the breather hoses from the factory air box.
6.
Remove the clamp holding the duct to the air box and remove the air
duct.
7.
Loosen the clamp holding the air box to the throttle body.
8.
Remove the two bolts holding the air box in place and remove the
air box.
9.
Place the Volant box onto the wheel well and tighten down with the
factory bolts, and install the lter.
10. Place the hump hose onto the lter box adapter and tighten the
clamp.
11. Slide the sleeve onto the duct and press the duct into the hump
hose, than slide the sleeve onto the throttle body and tighten the
clamps.
12. Install the MAF sensor using the volant MAF gaskets and tighten the
sensor into place.
13. Press the factory 5/8 breather hose onto the volant duct.
14. Press the supplied breather hose onto the volant duct and attach to
the factory hose using the stright tting provided.
15. Re install the negative battery cable.
MY
MAKE
MODEL
ENG.
06-09
TOYOTA
FJ
4.0L
RECOMMENDED SERVICE PARTS
PART NO.
POWERCORE FILTER UPGRADE
61513
REPLACEMENT COTTON FILTER
5119
PREFILTER
51906
SNORKEL KIT
38740
CLEANING KIT
5100
READ INSTRUCTIONS THOROUGHLY BEFORE DISASSEMBLING.
DO NOT SKIP ANY STEPS. ANY QUESTIONS ON A VOLANT KIT
MAY BE REFERRED TO OUR TECH SUPPORT LINE AT
(909) 481-3888 OR VISIT OUR WEBSITE AT
Volant Performance
Rancho Cucamonga, CA 91730
(909) 481-3888 Tech Support
(909) 476-1491 Fax
WARNING: OVER TIGHTENING HARDWARE MAY ALTAR THE INTEGRITY OF
THE VOLANT AIR INTAKE SYSTEM.
BEFORE ROAD TESTING
1.
Start engine, leaving the transmission in park and securing the parking brake.
2.
Make sure to look and listen for any unusual noises or air leaks. Repair
problems if needed.
3.
Once completed it will be necessary to check periodically for realignment and
tightening of all connections.
4.
Once all tests are completed, enjoy the performance of your new Volant Air
Intake System.
CARE AND CLEANING
Check the cotton reusable lter periodically and remove any excessive dirt build-up
by tapping the lter on the ground and brushing off the loosened dirt. Clean the
lter by using Volant’s Filter Recharger Kit. Volant’s Filter Recharger Kit is designed
to restore original air ow. Re-oil every 10,000 miles without cleaning to improve
ltering in sand and dirt. Clean only when dirt is very excessive or 50,000 miles.
INSTALLATION INSTRUCTIONS PART NO.
Installation Instructions:
RECOMMENDED SERVICE PARTS
APPLICATION GUIDE
INSTALL