Volant Sierra - Manual (Page 3)

Ram Air Scoop
07-12 GM Truck/SUV 4.8/5.3L/6.0/6.2L
PN 35353
7/29//2014
INS35353 Volant Performance · 140 Blaze Industrial Pkwy · Berea, OH 44017 · P: (909) 481.3888 · F: (440) 891‐1868
3
E-Mail: [email protected] www.volant.com
Installation Instructions:
1. Turn the vehicle to the max left and allow the engine to cool before beginning the install. (Fig A)
2. Remove the 2 10mm bolts holding the wheel liner to the support tray. (Fig B)
3. Remove the bolts holding the wheel well liner to the fender. (Fig C)
4. Remove the push pins from the front of the wheel liner. (Fig D)
5. Tie the liner back so you have access to the support tray and the bottom of the Volant air box. (Fig E)
6. Remove the support tray from the core support. (Fig F1 and F2)
7. Attach the provided 3 3/4 x 6in sleeve to the Volant box with a #60 clamp using a 5/16 socket or nut driver only.
(Fig G)
8. Press the ram air scoop into the sleeve until it makes contact with the lover valance using a jack will help
support the scoop while the brackets are installed. Loosen the fender liner so it can be pulled forward for the
next step. (Fig H1 and H2)
9. There are 2 sharp angled brackets included in the hardware bag, hold the brackets up to the ram air scoop and
use the bracket that best aligns with the fender liner. (Fig I1 and I2)
10. Had tighten the bracket to the scoop using the provided 1/4 x 20 bolts, 1/4 lock washers and 1/4 washers. (Fig
J)
11. Hand tighten the 6mm x 25 bolt, 7/8 washers, 1/4 lock washer and 6mm nut to hold the bracket to the fender
liner. (Fig K1 and K2)
12. Remove the bolt on the fender side of the body mount bracket. (Fig L)
13. There are 3 straight brackets included in the hardware bag, hold the brackets up to the ram air scoop and use
the bracket that best aligns with the frame mount. (Fig M)
14. Hand tighten the factory bolt into the frame. (Fig N)
15. Hand tighten the 1/4 20 bolt, 1/4 lock washer and 1/4 washer to the ram air scoop. (Fig O)
16. Adjust the scoop as necessary and tighten the scoop to the sleeve with a #60 clamp using a 5/16 socket or nut
driver only. (Fig P)
17. Tighten the factory bolts holding the wheel well liner to the fender. (Fig Q)