Volant Tundra 18857 User Manual
Page 2
18857
1. Disconnect the negative battery cable.
2.
Pull up on the engine cover and remove it.
3.
Remove the two breather hoses from the back of the factory air
duct.
4.
Remove the two screws holding the MAF sensor remove the sensor.
5.
Remove the two bolts holding the factory air box in place.
6.
Loosen the clamp holding the factory duct into place.
7. Remove the factory intake system.
8.
Place the two gaskets onto the Volant box.
9.
Attach the volant air duct onto the Volant box and tighten the pieces
together with the hardware provided.
10. Slide the reducer onto the Volant duct and place the system in the
factory position than slide the reducter onto the throttle body.
11. Tighten the Volant box down with the hardware provided and tighten
the clamps.
12. Remove the factory O-ring from the MAF sensor and and replace it
with the Volant gasket, tighten he sensor into the Volant duct.
13. Press the two breather hoses to the Volant duct.
14. Attach the Filter and lid to the Volant box.
15. Remove the foward most stud from the intake mainfold and thread
in the 6mm volant stud than attach the 6mm coupler to the stud and
thread the factory mounting stud into the coupler
16. Reinstall the engine cover and battery cable.
MY
MAKE
MODEL
ENG.
07-10
TOYOTA
TUNDRA
5.7L
08-10
TOYOTA
SEQUOIA
5.7L
RECOMMENDED SERVICE PARTS
PART NO.
REPLACEMENT POWERCORE FILTER
61508
PREFILTER
61521
READ INSTRUCTIONS THOROUGHLY BEFORE DISASSEMBLING.
DO NOT SKIP ANY STEPS. ANY QUESTIONS ON A VOLANT KIT
MAY BE REFERRED TO OUR TECH SUPPORT LINE AT
(909) 481-3888 OR VISIT OUR WEBSITE AT
Volant Performance
Rancho Cucamonga, CA 91730
(909) 481-3888 Tech Support
(909) 476-1491 Fax
WARNING: OVER TIGHTENING HARDWARE MAY ALTAR THE INTEGRITY OF
THE VOLANT AIR INTAKE SYSTEM.
BEFORE ROAD TESTING
1.
Start engine, leaving the transmission in park and securing the parking brake.
2.
Make sure to look and listen for any unusual noises or air leaks. Repair
problems if needed.
3.
Once completed it will be necessary to check periodically for realignment and
tightening of all connections.
4.
Once all tests are completed, enjoy the performance of your new Volant Air
Intake System.
CARE AND CLEANING
Check the cotton reusable lter periodically and remove any excessive dirt build-up
by tapping the lter on the ground and brushing off the loosened dirt. Clean the
lter by using Volant’s Filter Recharger Kit. Volant’s Filter Recharger Kit is designed
to restore original air ow. Re-oil every 10,000 miles without cleaning to improve
ltering in sand and dirt. Clean only when dirt is very excessive or 50,000 miles.
INSTALLATION INSTRUCTIONS PART NO.
Installation Instructions:
RECOMMENDED SERVICE PARTS
APPLICATION GUIDE
INSTALL