Voodoo Lab Pedal Power MONDO - Manual (Page 9)

- 7 -
Line 6
Tone Core pedals, plus Pocket POD can be powered from any available 9V
output. The M5 must use a 400mA high-current output with a standard black
5.5x2.1mm barrel cable.
You can power Line 6 modeling pedals, DL4 or MM4, using the red 5.5x2.5mm
barrel cable from either the 12V 400mA high-current outputs or outputs 5 and 6
with the DIP switch in the ON position. This does not match the rating of the
supplied Line 6 adapter, but does correctly power these pedals. Note that PODxt
& HD, M9, M13 and the JM4 Looper cannot be powered by Pedal Power
MONDO.
TC Electronic
TC Electronic’s Nova pedals such as the Delay, Modulator and Reverb are
powered from any high-current 400mA 12V output, or L6 250mA 9V output using
a standard black 5.5x2.1mm barrel cable. This does not match the rating of the
supplied TC Electronic adapter, but does correctly power these pedals.
Other TC Electronic pedals which can be powered from a 9V battery, such as the
Classic and TonePrint series, can operate from any 9V output.
Eventide
The Eventide stompboxes (TimeFactor, ModFactor, PitchFactor and Space) can
be powered from any 9V or 12V high-current 400mA output using the red
5.5x2.5mm barrel cable. The 12V output does not match the rating of the
supplied Eventide adapter, but does correctly power these pedals.
Important: While you can power the Eventide stompboxes from either 9V or 12V
high-current outputs, do NOT operate two Eventide pedals from the same
isolated section by using both 9V and 12V jacks of the pair. This WILL exceed
the 400mA current rating.