Voodoo Lab Pedal Power ISO-5 - Manual (Page 5)

- 3 -
Connections
Pedal Power ISO-5 is powered directly from mains using the supplied AC line
cord. This is a standard computer-type IEC line cord, so it’s easy to obtain a
replacement or different length.
Important: Pedal Power ISO-5 is manufactured to operate from a specific supply
voltage (100V, 120V or 240V) which is marked on the bottom of the unit.
Attempting to operate at the wrong voltage may cause permanent damage.
1) 9V outputs (3). Use for all ordinary pedals which operate from a 9V battery or
require less than 100mA.
2) 9V high-current output. Use for devices which require up to 300mA. These
effects will use multiple 1.5V batteries or a 9V regulated adapter (wall wart). This
output can also power ordinary low current pedals.
3) 12V high-current output. Use for all devices which require 12V at 300mA or
less. Most devices that use a 9V unregulated adapter should be powered from
this output.
Note: The 9V and 12V high-current outputs are not isolated from each other
(their negative terminals are common). It is preferred to use only one. If using
both, combined output should not exceed 300mA.
4) 18V output. Use for 18V pedals which operate from two 9V batteries or require
less than 100mA. Do not power 9V effects at 18V unless recommended by the
manufacturer.