Vermona PERfourMER MKII - quad analog synthesizer - Manual (Page 18)

LFO > MIDI-clock-synchronization
All of the PerFourMer MKII's LFOs can be beat-synced to a MIDI-clock. MIDI-
clock-synchronization can be enabled/disabled for each synthesizer
channel independently using EDIT-parameter 8: LFO MIDI CLOCK SYNC.
To do so, follow these steps:
1. Press the EDIT-button.
2. Select parameter 8: LFO MIDI CLOCK SYNC using the SELECT/SEQ
control.
3. Press TRIG to enable synchronization for one or several synthesizer
channels. The corresponding red LED above each TRIG-button will dis-
play the synchronization status. If the LED is lit, MIDI-sync is active.
4. Exit edit-mode by pressing the EDIT-button.
NOTE With MIDI-clock-synchronization being activated for
at least a single synthesizer channel, the green LED
above the MIDI CH-button will start blinking to indi-
cate clock-reception.
With MIDI-clock-synchronization being activated, SPEED/PHASE will control
the division of the incoming clock-signal, i.e. it sets the LFO's speed within
a grid, referenced to the MIDI-clock.
The outer labeling of the SPEED/PHASE control, indicates the eight available
clock-divisions. The divisions equal the following note values (left to right):
• whole note
• 1/2 note
• 1/4 note
• 1/4 triplet
• 1/8 note
• 1/8 triplet
• 1/16 note
• 1/32 note
Owner's Manual VERMONA PERfourMER MKII
- 18 -