beautypg.com

Dodge 2009 Challenger User Manual

Page 346

background image

24. Connect the air pump hose valve to the tire valve and
flip the hose valve closed.

25. Check the pressure in the tire by reading the pressure
gauge 4. If the pressure is 19 psi (1.3 bar) or greater,
proceed to the following step. NOTE: If the pressure is
less than 19 psi (1.3 bar), the tire is too badly damaged.
Do not attempt to drive the vehicle further. Call for
assistance.

26. Leave the parking brake set and the shift lever in
PARK (automatic transmission) or gear (manual trans-
mission) and start the engine.

27. Inflate the tire to the pressure indicated on the tire
pressure label on the driver-side latch pillar by pressing
the switch 3 on the air pump to I (ON) and watching the
pressure gauge. When the tire pressure is set to the
pressure indicated on the tire pressure label, press the
AIR PUMP switch 3 to 0 (OFF) and turn off the engine.

28. Disconnect the TIREFIT system from the tire and
reinstall the valve cap.

29. Place the sealant kit back in the trunk of the vehicle.
Replace the sealant bottle at your nearest authorized
MOPAR

௡ parts dealership.

30. Have the tire inspected at the earliest opportunity at
an authorized dealer or tire service center.

NOTE:

• If a pressure of at least 19 psi (1.3 bar) cannot be

maintained in the tire, the tire is too badly damaged.
Do not attempt to drive the vehicle further. Call for
assistance.

• Do not operate the electric air pump for more than

eight minutes to avoid overheating. The air pump may
be used again once it has cooled down.

• Replace the TIREFIT sealant bottle 5 once every four

years to assure optimum operation of the system.

344

WHAT TO DO IN EMERGENCIES

This manual is related to the following products: