Tube Tech PE 1C Program Equalizer - Manual (Page 2)

LYDKRAFT ApS
Mose Allé 20, DK2610 Rødovre
Denmark
2
CONTROLS:
LOW FREQUENCY
SECTION:
The low frequency section consists of a BOOST and ATTENuate
control and a LOW FREQUENCY switch located just below.
BOOST: The BOOST control is continuously variable from 0 dB to +14 dB.
It is of the shelving type.
ATTEN: The ATTENuate control is continuously variable from 0 dB to -18 dB.
It is of the shelving type.
LOW
FREQUENCY: The LOW FREQUENCY switch determines at which frequency the
maximum boosting and attenuation is obtained.
There is a choice of 4 frequencies:
20, 30, 60 and 100 Hz.
HIGH FREQUENCY
SECTION:
The high frequency section consists of two separate circuits:
1. A high frequency boost section, which contains a BOOST control, a
BANDWIDTH control and a HIGH FREQUENCY switch.
2. A high frequency attenuate section, which consists of a ATTENuate
control and a ATTEN SELECT switch.
BOOST SECTION:
BANDWIDTH: The BANDWIDTH control is continuously variable from SHARP to
BROAD. It controls the width of the high frequency boost curve.
(030507)