Tiptop Passive Bus - Manual (Page 2)

TM
ZEUS Series Passive Bus Board
w/ Power Supply
The ZEUS Passive Bus Board has the ability to connect to most 12V power
supplies of your choosing. You may also conveniently purchase the proper
supply from any of our distributors. This guide shows you how to properly
connect the wiring from power supply to the ZEUS Passive Bus Board.
The ZEUS Passive Bus Board Will need to be wired from your 12V power
supply using either the Screw Terminals located in the front, or the Flat
Terminals located on the back of the board.
When wiring using either connection format, please make sure to wire a
jumper from the +12V connection to the VR connection. This will power
the +5V rail used in conjunction with module requiring the extra 5V current.
For a more in depth introduction to the ZEUS power systems and how to
connect to our ZEUS Powered Bus Boards along with its additional set of
features please refer to our full manual.
http://www.tiptopaudio.com/products.php
-­ 12V
GND
+12V
VR
-­ 12V
GND
+12V
VR
Screw Terminals Flat Terminals