Semi-permanent installation – DeLonghi PAC-A130HPE User Manual
Page 3
134
5,27
in.
in the win-
dow pane
in the wall: it is
recommended
that you insulate
a section of the
wall using suit-
able insulation.
in the wooden
kickboard of
a French win-
dow
F
Semi-permanent installation
MAX100 cm
MAX 39,37 inches
MIN 35 cm
MIN 13,77 inches
SEMI-PERMANENT INSTALLATION
If required, your appliance can also be
installed semi-permanently (Fig. E).
Proceed as follows:
•
Drill a hole ø 5,25 inches (ø 134 mm) in an
outside wall or through a window pane.
Respect the dimensions and height of the
hole given in figure F and G.
•
Fit the wall flange
into the hole.
•
Fit the air exhaust hose
into the air
exhaust hose housing
located on the
rear side of the appliance (fig. A page 5).
•
Fit the end of the hose
to the wall
flange
as shown in fig. G.
8
11
12
12
11
G
When the hose
is not connected, the
drilled hole can be closed with the flange
cap .
NOTE: When installing the air conditioner
semi-permanently, you should leave a door
slightly open as little as 1/2 “ (1 cm) to guar-
antee correct ventilation and room pressure.
11
12
6
11,8 in
30 cm
11,8 in
30 cm
E
Keep the exhaust hose as short and free
of curves as possible to avoid constric-
tions.
“As special tools are required for installa-
tion, we suggest you have the applian-
ce installed by specialized personnel.”