Tenqa HP-109 - Manual (Page 4)

2
Operating Instructions
charging
Use the included USB cable to connect the HP-109 with a USB port on your
computer or with a USB wall adapter. Charging will start automatically when
the HP-109 is connected and the red indicator light will turn on. Once charging is
complete, the light will turn off. Make sure you charge the unit for at least 3 hours
before first use.
Power on/off
Press and hold the button with the phone symbol for about 4 seconds to turn on,
and two seconds to turn off.
Please note that the HP-109 needs to be paired with another Bluetooth source
before it can transmit voice or music.
Pairing
Note: Your audio device must support Bluetooth A2DP compatibility to connect
with the HP-109. Alternatively, you may pair the HP-109 with a Bluetooth transmit-
ter connected to your audio device. This guide does not provide steps for pairing
your stereo headset with these devices. Please consult the user manual for the
device with which you are attempting to pair for operating instructions.
“Pairing” means creating a trusted relationship between two or more Bluetooth
devices. The devices must be paired before they can communicate with each other.
Pairing identification is stored for later use, and the devices will automatically
recognize each other the next time they are connected.
After successfully pairing for the first time, you simply need to follow the direc-
tions for POWER ON/OFF above for your device to be recognized by your mobile
phone.
Note: Make sure the HP-109 is “off” before starting the Pairing procedure.
how to pair with mobile phones, android, iPhone®, iPad®, iPod touch®
Place the HP-109 within 30 cm of the device with which you are pairing. 1.
Hold down the “phone button” for about 6 seconds and you will see the indica- 2.
tor light flash half red/half blue and hear a tone. CONTINUE HOLDING the
button until you hear another tone (about 9 seconds total) and the red and blue
light flash intermittently. This indicates the device is in pairing mode.