Taser M26 - Manual (Page 8)

ADVANCED TASER® M26 Operating Manual • MMU0008 Rev: B
TRIGGER
Unlike a firearm trigger, the ADVANCED TASER M26 trigger is a
momentary electrical switch. The switch is operational only
when the safety switch is in the up (ARMED) position. Depressing
and releasing the trigger will result in a five-second discharge
unless the safety switch is moved to the down (SAFE) position.
Holding the trigger switch for more than 5 seconds will result in a
continuous discharge until the trigger switch is released, or until
the batteries are depleted.
WARNING: In the event of an accidental discharge, immediately move the safety switch to
the down (SAFE) position to stop the discharge cycle.
MECHANICAL SIGHTS
The mechanical sights on the M26 are molded to provide manual
aiming of the M26.
ELECTRODES
The front of the M26 contains two metal electrodes. These
electrodes direct the charge to the electrodes on the cartridge
to initiate deployment of the probes. In addition, the electrodes
provide the ability to use the M26 in a “drive-stun” mode as a
traditional stun-gun type device.
15, 21, LS, XP25, AND XP35 TASER CARTRIDGES
Specifications are available at www.TASER.com and are subject to change without notice.
AFID LABEL
CASSETTE WEDGE
AFID STACK
PORON PADS
EJECTORS
MYLAR BLUNT FRONT PROBE ASSEMBLY
SNAP ON BLAST DOOR
WIRE SPOOL
NITROGEN GAS CAPSULE & PRIMER
CASSETTE ELECTRODE
CARTRIDGE CUTAWAY