StorCase Technology DX115 - Manual (Page 13)

6 Introduction
StorCase Technology, Inc. SATA 3Gbps DX115 User's Guide - Rev. A02
Receiving Frame Rear Panel
(Figure 4)
Figure 4: Receiving Frame Motherboard
(Rear View)
I/O
Connector
Reserved
Pins
SATA Power
Connector 1
2 4
3
6
5
Drive Activity
LED Pin
GND
Cooling
Fan
• I/O Connector - The input/output connector provides a standard interface for all
SATA signals.
• SATA Power Connector - 15-Pin SATA power connector to accept DC power.
NOTE: If your system does not accommodate the SATA power connector, simply
use the SATA-to-DC Power adapter cable (included in the accessory
bag) to connect to your system's DC power.
• Drive Activity LED Pins - Pin 1 is used for host connection (cable not included) to the
Drive Activity LED (Figure 1). Some SATA PC systems/host controllers provide support
for the Drive Activity LED feature (refer to the SATA PC system/host controller manu-
facturer's documentation for further information).
• Factory Reserved Pins - These pins are reserved for factory use only - Do not install
jumper under any circumstances!
• Cooling Fan - Field-replaceable fan provides ample cooling (4.6 CFM) for drive.