Sonodyne SBA 1202P - Manual (Page 4)

Page 2
SMA/ SBA SERIES
IMPORTANT SAFETY INFORMATION
13. Do not block fan intake or exhaust ports. Do not operate equipment on a surface or in an
environment which may impede the normal flow of air around the unit, such as a bed, rug, weather
sheet, carpet, or completely enclosed rack. If the unit is used in an extremely dusty or smoky
environment, the unit should be periodically “blown free” of foreign matter.
14. Do not remove the cover. Removing the cover will expose you to potentially dangerous voltages.
There are no user serviceable parts inside.
15. Do not drive the inputs with a signal level greater than that required to drive equipment to full
output.
16. Do not connect the inputs / outputs of amplifiers or consoles to any other voltage source, such as a
battery, mains source, or power supply, regardless of whether the amplifier or console is turned on or
off.
17. Do not run the output of any amplifier channel back into another channel's input. Do not parallel- or
series-connect an amplifier output with any other amplifier output. Sonodyne is not responsible for
damage to loudspeakers for any reason.
18. Do not ground any (“hot”) terminal. Never connect a “hot” output to ground or to another “hot”
output!
19. Non-use periods. The power cord of equipment should be unplugged from the outlet when left
unused for a long period of time.
20. Service Information Equipment should be serviced by qualified service personnel when:
A. The power supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the equipment
C. The equipment has been exposed to rain
D. The equipment does not appear to operate normally, or exhibits a marked change in performance
E. The equipment has been dropped, or the enclosure damaged.
THIS SAFETY INFORMATION IS OF A GENERAL NATURE AND MAY BE SUPERSEDED BY INSTRUCTIONS
CONTAINED WITHIN THIS MANUAL