Rupert Neve Portico 5032 - Mic Pre / EQ - Manual (Page 12)

SPECIFICATIONS
Frequency Response:
Main Output, no load,
–0.2 dB @ 10 Hz
–3 dB @ 160 kHz
Noise:
Measured at Main Output, unweighted, 22Hz-22kHz,
Terminated 150 Ohms.
With gain at unity
better than –100 dBu
With gain at 66 dB better than –62 dBu
Equivalent Input Noise better than –128 dBu
High Pass Filters:
Continuously variable swept frequency from 20 Hz to 250 Hz.
Slope:
12 dB/Octave
Gain:
Unity to +66dB in 6 dB steps,
Trim continuously adjustable from –6dB to +6dB
Buss Output:
Output is designed to feed a Buss-mix Amplifier (ie. Buss inputs on 5043) at the
internal system level of -2.5 dBu.
Maximum Output Level:
Maximum output from 20 Hz to 40 kHz is +25 dBu.
Mute:
Mutes Main Output only.
Total Harmonic Distortion and Noise:
@ 1kHz, +20 dBu output:
Main Output:
Better than 0.001%
@ 20Hz, +20 dBu output:
Main Output:
Better than 0.002%
Silk Engaged: Better than 0.2% Second harmonic
Equalization:
Low Shelving EQ:
+/- 15dB boost or cut. Corner frequency 160Hz
High Shelving EQ:
+/- 15dB boost or cut. Corner frequency 8kHz 16kHz switch selectable
Mid Peak EQ:
+/- 15dB boost or cut. Continously variable frequency, 80 to 800Hz or
800Hz to 8000Hz switchable
Phantom Power:
+48 Volts DC +/- 1%
Power requirements:
Voltage range: 9 to 18 Volts DC
Current consumption:
@ 9VDC Current is 910 mA typical: Power = 11.7W
@ 12VDC Current is 670 mA typical: Power = 12.0 watts
@ 15VDC Current is 530 mA typical: Power = 12.0 watts
@ 18VDC Current is 450 mA typical: Power = 11.7 watts
Connector: 5.5mm X 2.1mm DC jack, Center Positive
11