Delta AP-100 - Manual (Page 8)

8
ASSEMBLY
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 30 minutes.
PULL CORDS
Insert the cord (A) Fig. 1 in the pull cord catch (B). Repeat this process for the remaining pull cord.
FLUORESCENT BULBS (NOT INCLUDED)
1. Thread a 5/16-18 flange nut (B) Fig. 3, on a 5/16-18 x 1-1/2" eye bolt (C).
2. Thread the eye-bolt (C) Fig. 3 in the hole (D).
NOTE: Tighten the eye-bolts at least eight complete turns.
3. Tighten the flange nut (B) Fig. 3 against the air cleaner.
4. Repeat this process for the remaining hole in the top of the air cleaner (Fig. 4).
MOUNTING THE AIR CLEANER TO THE CEILING OR OVERHEAD SUPPOR
This tool weighs approximately 40 pounds. Make certain the unit is securely supported when mounting it
to a ceiling or overhead support.
Never secure the air cleaner hardware to drywall, drop ceiling tile/frame, or other non-structural
members.
No assembly tools are required.
For your own safety, do not connect the machine to the power source until the machine is
completely assembled and you read and understand the entire instruction manual.
A
B
Fig. 1
IMPORTANT: This unit uses standard 18"x1", 15 watt fluorescent light bulbs.
1. Insert one end of the bulb (A) Fig. 2 through the slot (B). Repeat this step for the other end of the bulb.
2. Twist the bulb 1/4 turn to lock it in place.
3. Repeat this process for the remaining bulb.
B
A
Fig. 2
Fig. 3 Fig. 4
D
B
C