ROHO SOFFLE 2 mattress overlay system operation manual - Manual (Page 9)

9
ADJUSTMENT INSTRUCTIONS FOR:
• Standard Overlay • SOFFLEX 2 • PRODIGY
• Bariatric Overlay • O.R. Pad
STEP 5: Reapply bed linens (maximum one sheet, one draw sheet, or one incontinent pad). Place end-user
on the mattress overlay in their normal lying position. (For demonstration purposes, linens not shown).
STEP 1: Remove all bed linens except support
mattress pad or sheet from existing bed
mattress. Place mattress overlay sections
cell side up, on top of the bed mattress. Align
mattress overlay sections and snap together.
STEP 2: Turn valve counter-clockwise to open.
NOTE: If more than one valve per section, only
open one. NOTE: SOFFLEX 2 and PRODIGY,
valves are located on bottom surface.
STEP 3: Slide the pump’s rubber nozzle over the
valve and inflate mattress overlay section until
it arches slightly upward.
STEP 4: Turn valve clockwise to close. Remove
pump. Repeat steps 2- 3 for remaining mattress
overlay sections.
STEP 6: For proper immersion of each section, slide your hand between the mattress overlay and the
end-user under the lowest bony prominence (see image). Release air from section until area of high risk
is within the suggested Inflation Guidelines (see table on next page). Turn valve clockwise to close.
Repeat Step 6 for remaining sections.
NOTE: The adjustment sequence noted in the diagram is ROHO's recommendation; sequence may
vary by individual end-user's needs.