Controls and function descriptions – Rocktron Utopia Bass Wah User Manual

Page 9

ROCKER FOOTPEDAL - Place your foot on the rocker foot-

pedal and rock it up and down (toe to heel - heel to toe) to work

the “ wah” effect.

Wah ON/OFF Switch - is located under the toe of the rocker

footpedal. To activate the “wah” press down slightly harder on

the toe of the rocker pedal until the switch is activated. The

same process is to be applied to turn off the wah effect.

INPUT Jack - using a standard guitar/bass cable - plug your

bass into this jack.

9-VOLT ADAPTER INPUT - This receptacle requires a 9V DC

adapter (not included) with a 2.1mm coax plug to provide pow-

er to the unit. Please consider using the Rocktron DC OnTap

adapter (sold separately) available from your Rocktron dealer.

Note: If an adapter other than the Rocktron DC OnTap adapter is used, it needs to be a 9V DC

ﬁltered audio grade type with a current rating of 100ma or greater . The plug is a 2.1mm Coax

jack (Tip is Negative and Sleeve is Positive). Please follow all instructions that appear on the

bottom of the Utopia Wah.

OUTPUT Jack - using a standard guitar/bass cable, plug this

output into the next effect in your effect chain or directly into the

input of your ampliﬁer.

9-VOLT BATTERY COMPARTMENT - to access pull on

small tab labeled “OPEN”. Replace with a new 9-Volt battery.

Always remember to unplug your guitar cords from the pedal to

conserve battery life. Some battery drain may take place when

unit is plugged in (even if the unit is bypassed).

Controls and Function Descriptions