Rocktron Classic Wah - Manual (Page 9)

ROCKER FOOTPEDAL - Place your foot on the rocker foot-
pedal and rock it up and down (toe to heel - heel to toe) to work
the “ wah” effect.
Wah ON/OFF Switch - is located under the toe of the rocker
footpedal. To activate the “wah” press down slightly harder on
the toe of the rocker pedal until the switch is activated. The
same process is to be applied to turn off the wah effect. The
wah effect will be on when the red LED is lit (see point 7).
INPUT Jack - using a standard guitar cable - plug your guitar INPUT Jack INPUT Jack
into this jack.
PEDAL ROCKER TENSION ADJUSTMENT - This screw will
allow you to adjust the “action” of the pedal to suit your taste
with the included allen wrench. If you would like a tighter or
heavier movement of the pedal using an allen wrench turn the
screw clockwise. This will increase the torque and tension on
the rocker pedal. If you would like a smoother or softer pedal
movement turn the allen screw counter-clockwise. This will
loosen the tension on the pedal pivot point.
9-VOLT ADAPTER INPUT - This receptacle requires a 9V DC
adapter (not included) with a 2.1mm coax plug to provide pow-
er to the unit. Please consider using the Rocktron DC OnTap
adapter (sold separately) available from your Rocktron dealer.
Note: If an adapter other than the Rocktron DC OnTap adapter is used, it needs to be a 9V DC
fi ltered audio grade type with a current rating of 100ma or greater . The plug is a 2.1mm Coax
jack (Tip is Negative and Sleeve is Positive). Please follow all instructions that appear on the
bottom of the Classic Wah.
1
2
3
4
5
Controls and Function Descriptions