Rocktron Velocity V50C - Manual (Page 4)

HIGH INPUT jack
This is a high impedence input jack. Connect the output of your guitar to the 1/4” input jack with a shielded
guitar cable. Use this jack if you want a little more “edge” to your input. Note use only the High or the
Low input, not both at the same time.
GAIN control
This knob determines the amount of GAIN (or distortion) added to the clean signal. Turning the knob
clockwise will add more GAIN to the signal. Turning the knob counter-clockwise will decrease the amount
of GAIN added to the signal.
CH SELECT Button /CLEAN & DIST. LEDs
Channel Select button allows you to select between the CLEAN or the DISTORTION channel. When the
CLEAN LED is ON (or lit) the CLEAN channel is active. When the DIST. LED is ON (or lit) the DIS-
TORTION channel is active.
6
7
DISTORTION CHANNEL
LEVEL control
This knob determines the LEVEL (or volume) of the CLEAN channel. Turning the knob clockwise will
increase the LEVEL of the clean channel. Turning the knob counter-clockwise will decrease the LEVEL of
the clean channel.
CLEAN CHANNEL
LOW INPUT jack
This is a low impedence input jack. Connect the output of your guitar to the 1/4” input jack with a shielded
guitar cable. Use this jack if you want a little less “edge” to your input. Note use only the High or the Low
input, not both at the same time.
GAIN control
This knob determines the amount of GAIN (or distortion) added to the signal in the distortion channel.
Turning the knob clockwise will add more GAIN to the signal. Turning the knob counter-clockwise will
decrease the amount of GAIN added to the signal.
LEVEL control
This knob determines the LEVEL (or volume) of the distortion channel. Turning the knob clockwise will
increase the LEVEL of the distortion channel. Turning the knob counter-clockwise will decrease the
LEVEL of the distortion channel.
INPUT JACKS
FRONT PANEL DESCRIPTIONS
1
2
3
4
5