Rocktron Rampage R120 - Manual (Page 6)

2
Front Panel
9
INPUT jacks - LOW and HIGH
Connect the output of your guitar to one of the 1/4" input jacks with a
shielded guitar cable. Select LOW for normal, or HIGH for extra gain.
PREAMP GAIN - DRIVE and CLEAN controls
The DRIVE channel is designed with increased gain for more
overdrive while the CLEAN channel has less "built-in" gain for clean
sounds.
CH SELECT button and DRIVE LED
Select DRIVE channel or CLEAN channel. The DRIVE LED is ON
when the DRIVE channel is active.
MASTER volume control
The MASTER volume control adjusts the overall sound level. Once
the gain is set, adjust this control for the appropriate listening level.
REVERB control
Adjusts the amount of reverb added to your guitar's signal. Turn the
knob clockwise to increase the effect.
CHORUS button
Push IN to activate CHORUS. The ON/RATE LED is illuminated
when CHORUS is ON and flashes to indicate RATE speed.
RATE control
This controls the delay time for the CHORUS effect. Lower RATE
settings result in slower sweep speeds. Higher settings result in
faster speeds. The ON/RATE LED, next to the CHORUS button,
flashes to indicate the RATE speed.
DEPTH control
Controls the modulation depth for the CHORUS effect. Lower
DEPTH settings (counterclockwise) produce a more subtle detune
effect, while higher settings produce a more extreme detuning effect.
TREBLE/MID/BASS controls
Tone controls, or EQ. The BASS control boosts or cuts the amount
of low frequency, or bass sound. TREBLE does the same for the
high frequencies. MID adjusts the midband frequencies.
1
2
3
4
5
6
7
8
1 3
4
5 6
7
8
9
10
11
2